







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Toto Bathroom Remodeling: The Sunnyvale Owner’s Guide
If a Toto fixture in your Sunnyvale bathroom has failed or is failing, we install the replacement part and the surrounding bathroom work it touches, and a full bathroom remodel in Sunnyvale typically runs $9,000 – $28,000 depending on scope. A single part swap sits at the low end; a failed valve that has damaged tile, substrate or a vanity pushes toward the middle and top. Most Sunnyvale owners find the problem the same way: a toilet that won’t stop running, a washlet that quits mid-cycle, a fill valve that hisses at 2 a.m., or water staining on the ceiling below. To be clear, Penhallow Remodeling Sunnyvale is an independent remodeler, not affiliated with Toto; we source genuine Toto parts and install them to spec.
Which Toto Models This Applies To
Toto’s lineup splits into two families that matter here. The gravity and pressure-assisted toilets (the Drake, Ultramax, Eco series, and the Aquia) use a fill valve, flush valve and, on some models, a specialty flapper or a dual-flush tower. The washlet and integrated smart models (the S550e, C5, and the Neorest line) use a control board, a pump assembly, a bidet wand motor and a seat sensor, and those parts are model-specific down to the revision number. Identifying the right part starts with the model plate, usually behind the tank lid or on the underside of the washlet seat, and the serial number stamped beside it. Measure the rough-in (the distance from the finished back wall to the center of the floor drain flange) because Toto sells 10-inch and 12-inch rough-in versions of the same toilet, and the wrong one won’t seat. On the OEM-versus-aftermarket question, we install genuine Toto for washlets and smart models because aftermarket boards and pumps frequently fail on the revision mismatch. For older gravity toilets, a quality aftermarket fill valve is a reasonable, honest saving.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Toto Bathroom Remodeling Is Failing
- The toilet runs long after the flush. A worn flapper or a fill valve that no longer shuts off cleanly. In Sunnyvale’s soft water this is usually simple wear, not mineral scale, so the part itself is the culprit.
- The washlet won’t spray or sprays weakly. A clogged wand filter, a failing pump, or a control board sending no signal. A weak single stream usually points to the pump; no spray at all points to the board.
- The seat won’t heat or the remote is dead. A failed heating element or a sensor that has drifted out of range. On the S550e and C5, this is often a board issue rather than the heater.
- Water pooling at the base or a wobble. A failed wax ring or a loose closet flange, and sometimes a cracked horn on the toilet itself. Left alone, this is what rots the subfloor and stains the ceiling below.
- Ghost flushing or a hiss you can’t place. A slow leak past the flapper or a fill valve that never fully seats. The hiss is water escaping; the ghost flush is the tank refilling on its own.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Installed prices in Sunnyvale land in these ranges, parts and labor together:
| Job | Installed range |
|---|---|
| Toilet fill valve or flapper swap | $180 – $400 |
| Wax ring and flange repair | $250 – $550 |
| Washlet pump or control board replacement | $400 – $900 |
| Bathroom vanity installation (if water damage forces it) | $800 – $3,000 |
| Full bathroom remodel, Toto fixtures included | $9,000 – $28,000 |
What drives the number up: whether the failure damaged tile, substrate or cabinetry; whether the model is a smart washlet with an expensive board; and whether the rough-in or flange needs correction. We give you a written price before any work starts, so the number on day one is the number on the invoice. Every job carries our 365-Day Done Right Promise in writing, plus a free return visit if a repair fails.
DIY or Call Us?
You can safely shut off the water at the angle stop, lift the tank lid to watch whether the flapper seats, check the model plate, and confirm the rough-in with a tape measure. Those checks are free and tell you a lot. Where it goes wrong: a wax ring that isn’t seated evenly will leak under the floor for weeks before you notice, and washlet control boards and pumps are easy to order in the wrong revision and hard to seat without damaging the waterproof connector. If your Toto has water at the base or a smart seat that’s dead, call us rather than guess. Call (888) 426-8719 to schedule your free estimate.
FAQs

How long does a Toto part last? A fill valve or flapper typically lasts 5 – 10 years, and a washlet pump or board usually gives 7 – 12 depending on use. Sunnyvale’s soft water is gentle on valves, so wear, not scale, is usually what ends them. Call (888) 426-8719 for an exact quote; estimates are free.
Can it be repaired instead of replaced? Often yes. A flapper or fill valve is a repair, not a replacement, and a washlet filter clean-out can restore spray without a new pump. We tell you honestly when a repair will hold and when a part is at the end of its road. Call (888) 426-8719; estimates are free.
How long does the swap take? A fill valve or flapper is under an hour, a wax ring and flange is one to two hours, and a washlet pump or board runs one to two hours. We give you a written arrival window and keep it. Call (888) 426-8719 to schedule your free estimate.
How do you source the Toto part? We order genuine Toto parts matched to your model and revision number, and for older gravity toilets we’ll use a quality aftermarket valve when it’s the honest call. We also install KraftMaid, Cambria and Silestone when a part failure turns into a full remodel. Call (888) 426-8719 for a free estimate.
Written by the team at Penhallow Remodeling Sunnyvale, serving Sunnyvale and nearby areas.












