







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Kitchen Remodeling: The Sunnyvale Owner’s Guide
Schluter-compatible kitchen remodeling in Sunnyvale typically runs $14,000 – $45,000 installed, depending on layout, cabinet line, and countertop material. That range covers waterproofing, tile work, cabinets, and countertops set with genuine Schluter systems or their direct equivalents. Most Sunnyvale owners we meet didn’t plan to learn about uncoupling membranes and shower-profile seals. They found out because a grout line cracked along the countertop, a tile loosened near the sink, or water showed up under the kitchen floor months after a remodel that seemed fine at first.
Here’s what’s actually happening in those kitchens: the waterproofing layer under the tile, or the edge profiles holding the tile in place, has failed. When a Schluter-system floor or wall goes bad in a Sunnyvale kitchen, the visible symptom almost always traces back to how the membrane was bonded, how the joints were sealed, or how the tile was set over it. The guide below covers the systems that fail, which model lines they belong to, what a correct replacement costs, and when it’s worth picking up the phone.
Which Schluter Models This Applies To

Schluter doesn’t make kitchen appliances or cabinets. What they make is the tile setting and waterproofing system that most quality kitchen jobs are built on: Ditra and Ditra-Heat uncoupling membranes for floors, Kerdi and Kerdi-Band for waterproofed surfaces, Kerdi-Board for backer panels, and a full family of profiles (Schiene, Dilex, Reno-U, Quadec) for tile edges and inside corners. If your kitchen was remodeled in the last fifteen years, there’s a strong chance one or more of these systems is what’s under your tile or behind your backsplash.
Identifying what you have matters before anything gets replaced. Pull a single loose tile or inspect under a cabinet toe-kick and you’ll see either an orange grid (Ditra), a gray fleece-faced sheet (Kerdi), or a cement board with a foil-look underlayment. Measure the thickness: standard Ditra is about 1/8-inch, Ditra-XL about 5/16-inch, and Kerdi-Board comes in 1/4-inch, 3/8-inch, 1/2-inch, and 3/4-inch nominal panels. Those thicknesses aren’t interchangeable when you’re resetting tile to an existing finish height.
The OEM-versus-aftermarket question is real here. Schluter’s own membranes are the reference standard, but there are quality equivalents (Laticrete, Custom Building Products, Mapei) that installers use daily. The gotcha: some membranes require a modified thin-set bond, others require unmodified, and mixing the wrong one is a top cause of early failure in Sunnyvale kitchens. Match the system, not just the look.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Kitchen Remodeling Is Failing
Failure rarely announces itself. It shows up in small ways over months, and by the time most Sunnyvale owners call us, the underlying problem has been growing a while. These are the symptoms worth paying attention to:
- Grout cracking in a repeating pattern. Grout that cracks along the same grout lines every few months usually means the tile is moving slightly underfoot, which points to an uncoupling problem rather than bad grout.
- Hollow-sounding tile near the sink, range, or dishwasher. Tap the floor or backsplash with a screwdriver handle. A dull thud in a wet zone is the sound of a debonded tile, often from moisture finding a weak seam.
- Lifted or separated edge profiles. A Schluter profile that’s pulling away from the tile edge, or a Dilex corner that’s open at the joint, means the seal has failed and water is getting behind it.
- Soft spots or discoloration at the kitchen threshold. A dark stain or a spongy step at the transition to the next room is a waterproofing breach that’s been working quietly for a while.
- Water showing up in the room below. If there’s a basement, garage, or crawlspace under your Sunnyvale kitchen, a stain on the ceiling or joist is the clearest signal that the membrane has failed.
None of those symptoms fix themselves, and they don’t respond to a grout touch-up. The membrane is what failed, and that’s what has to be addressed.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For Sunnyvale kitchens, here are the installed ranges to plan around:
| Scope | Installed Price Range |
|---|---|
| Full kitchen remodel (Schluter-system tile floor, cabinets, countertops) | $14,000 – $45,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation (Cambria, Silestone, or quartz) | $2,000 – $6,500 |
| Backsplash installation with Schluter profile edging | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
The range on the full remodel is driven by three things: square footage of tile work, whether the floor is being replaced or just reset, and the cabinet and countertop line you choose. Tile-to-tile repair is on the low end. A full tear-out where the membrane has failed across the whole floor lands near the top. Every quote is written line-item before any work starts: what’s being removed, what membrane system is going back in, what cabinets and countertops are being installed, and what the removal and disposal costs. The price you get on day one is the price on the invoice. The 365-Day Done Right Promise covers the install for a full year, and if the tile work or any part of the job fails inside that window, we come back and fix it at no charge. Cambria and Silestone carry their own product warranties alongside ours.
DIY or Call Us?
Some things are worth checking yourself. Others aren’t. Tap-testing a floor for hollow tile is safe and useful. Looking for a loose profile at the tile edge is fine. Checking under the sink cabinet for staining or a soft floorboard is fine. Reading the tube of thin-set to confirm whether it’s modified or unmodified is fine, and honestly worth doing.
What isn’t worth trying solo: pulling and resetting large-format tile without spending more than a install would cost, re-bonding a Ditra membrane into a wet zone, or chasing the source of water intrusion under a kitchen floor. Tile removal is dusty and violent, and the substrate underneath is usually the problem. A failed membrane in a Sunnyvale kitchen almost always has a source, and pulling everything up without diagnosing where the water came from means the new install fails the same way. One honest caution: if you smell mildew or see black staining under the floor or in the crawlspace, treat it as a moisture problem first and don’t re-tile over it. Give us a call at (888) 426-8719 and we’ll schedule a free estimate, usually within a few days and always with a written price before anyone lifts a tile.
FAQs

Fifteen to thirty years is typical when the membrane is installed correctly and bonded with the right thin-set. In Sunnyvale, the biggest lifespan hit comes from moisture, not from the Schluter system itself. Heated floors, dishwasher leaks that went unnoticed, and slab moisture pushing up through the substrate are the usual culprits. A floor installed correctly over a properly prepped substrate regularly hits the thirty-year mark.
Sometimes. A small area of tile over a failed seam can often be repaired by resetting the tile and re-bonding the membrane at that joint. A full floor failure or a membrane that’s lost bond across a wet zone usually can’t be patched in a way that lasts. Our estimate will tell you which one you’re looking at, with a written price for both options so you can decide.
A modest kitchen tile floor with a small backsplash typically runs three to five working days from demo to grout cure. A full kitchen remodel that includes cabinets and countertops with the Schluter-system tile work runs two to four weeks in Sunnyvale. We commit to an arrival window on the first day and give you a written schedule with the quote.
We source the membrane, profiles, and thin-set from authorized distributors, not from a resale pile. That means the Ditra or Kerdi going into your Sunnyvale kitchen is current production, comes with whatever manufacturer warranty applies, and is matched to the correct thin-set for that specific system. If your existing kitchen already has a Schluter system installed, we match what’s there so the new work doesn’t fight the old.
We also install cabinets from KraftMaid and countertops from Cambria and Silestone when they fit the project.
Penhallow Remodeling Sunnyvale is an independent remodeling contractor and is not affiliated with Schluter Systems. We install and repair Schluter-compatible kitchen systems, and every estimate we write is free.
Call (888) 426-8719 to schedule your free estimate. A live person answers the phone 24/7, so you won’t land in a voicemail queue. We’ll take a look at what’s failing, price it in writing, and tell you honestly whether you’re facing a tile repair or a fuller kitchen rebuild. Our technicians bring up to 22 years of experience to every job, and they arrive background-checked and in uniform. The 365-Day Done Right Promise applies to every project we take on in Sunnyvale and the surrounding area.
Written by the team at Penhallow Remodeling Sunnyvale, serving Sunnyvale and nearby areas.












