







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Kitchen Remodeling: The Sunnyvale Owner’s Guide
If your Mr-Glass kitchen has a failed part, we install Mr-Glass-compatible kitchen remodeling for Sunnyvale homeowners, with typical full remodels running $14,000 – $45,000 depending on layout, cabinet line and countertop material. Smaller jobs, like a cabinet refresh or a countertop swap, land well under that. We’re an independent service provider and not affiliated with Mr-Glass, but we know their product line and the parts that fit it.
Owners usually discover the failure slowly. A cabinet door that won’t sit flush. A drawer that grinds or sags at one corner. A countertop seam that has opened up near the sink. Or a hinge that was fine last spring and now lets the door hang a quarter inch low. By the time someone calls us in Sunnyvale, they’ve usually lived with it for a few months and tried one fix that didn’t hold.
Key Takeaways
- Mr-Glass-compatible kitchen remodels in Sunnyvale typically run $14,000 – $45,000.
- Cabinet installation alone runs $4,000 – $13,000; countertops $2,000 – $6,500.
- We write the price before work starts, back it with the 365-Day Done Right Promise, and answer the phone 24/7 with a live person.
- Older Mr-Glass hardware and cabinet runs can often be matched, but the label and measurements matter more than the model name.
Which Mr-Glass Models This Applies To

Mr-Glass has produced kitchen cabinetry and component runs across several model and series lines over the years, and the parts are not interchangeable between them. The single biggest compatibility gotcha we see in Sunnyvale is this: the same drawer glide was used in two different cabinet series with a 5mm difference in the mounting plate, and the aftermarket glide that “fits Mr-Glass” only fits one of them. Get the plate measurement wrong and the drawer binds within a week.
To identify the right part, start with the label inside the cabinet door or on the back of the drawer box. Look for a model or series code, then measure the hinge cup bore (commonly 35mm), the drawer glide length and the mounting screw spacing. Photograph all three with a tape measure in frame. If the label is gone, the measurements alone usually get us to the right part.
On the OEM-versus-aftermarket question for Mr-Glass specifically, we’re honest: OEM parts match exactly and are the safest call when the cabinet face and finish are original. Quality aftermarket equivalents (Blum, Grass, Hettich-style glides and hinges) are often stronger and cheaper, but the mounting pattern has to match or you’re drilling new holes. We’ll tell you which way makes sense for your kitchen before anyone touches a screwdriver.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mr-Glass Kitchen Remodeling Is Failing
- Cabinet doors that won’t stay aligned. Worn hinge cups or stripped screws in the cabinet frame. The door drops, rubs the next one, and no amount of adjusting fixes it for long.
- Drawers that grind or sag at one corner. A failing glide or a side-mount that’s pulled loose from the box. Left alone, the box itself starts to rack and the whole drawer needs replacing.
- Countertop seams that open near the sink or cooktop. Moisture and thermal movement working on a seam that wasn’t bedded properly. In Sunnyvale’s dry summers and damp winters, that cycle runs twice a year.
- Water staining or swelling at the cabinet base. A slow leak from the sink supply or a failed caulk line. Particleboard swells and never comes back, so the cabinet bottom has to be cut out and replaced.
- Backsplash tile cracking or popping loose. A substrate that moved after install, or adhesive that failed. Behind it, the drywall is usually soft.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For Sunnyvale, here’s what the work actually runs, with parts and labor together:
| Scope | Installed price range |
|---|---|
| Full kitchen remodel | $14,000 – $45,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
What drives the number up or down: cabinet box count and the cabinet line (KraftMaid and Wellborn both fall in a wide band), countertop material (Cambria and Caesarstone quartz sits above laminate), and whether we’re matching an existing Mr-Glass run or replacing a whole bank of cabinets. We also install Silestone and Cambria quartz, which carry their own manufacturer warranty alongside ours.
Every job gets a written price before work starts, not a range. If the number changes after demo, that’s on us, not on you. Every project is covered by the 365-Day Done Right Promise, and if something fails inside that window we come back and fix it at no charge.
DIY or Call Us?
Some checks are safe and worth doing yourself. Open the cabinet door and look for the label. Measure the hinge cup and the glide length. Photograph the failed part with a tape measure in the frame. Confirm whether the cabinet face is original or has been refinished. Those five steps save time on the phone and often narrow the part down to two or three options.
Where DIY goes wrong on this work: cabinet hardware that has to be re-bored, countertop seams that need to be re-bedded, and any cabinet base that has swollen from a leak. Re-boring a hinge plate by hand without a jig is how a matched Mr-Glass door becomes a door that never sits right again. Countertop work is heavier than it looks and unforgiving if a seam is off by a millimeter. And anything behind a wall or under a sink needs to be opened up and inspected, not caulked over.
If you’ve tried one fix and it didn’t hold, that’s usually the point to call us. Call (888) 426-8719 for a free estimate.
FAQs

A quality soft-close hinge or glide should last 10 – 15 years under normal daily use. In Sunnyvale’s climate, where interior humidity swings between dry summer air and damp winter air, the failure point is usually the mounting plate or the screws, not the hinge itself. Call (888) 426-8719 for an exact quote on replacement, estimates are free.
Often yes. A hinge that’s just come loose can be re-seated with longer screws or a wood plug in the cabinet frame. A drawer glide that’s binding can sometimes be cleaned and re-mounting. What can’t be repaired is a swollen cabinet base or a stripped screw hole in particleboard, both of which need to be cut out and replaced. We’ll tell you which one you’re looking at. Call (888) 426-8719 for a free estimate.
A single hinge or glide swap takes about 20 – 30 minutes per part. A full cabinet door run with new hinges and glides takes a half day. A countertop seam repair or a cabinet base replacement takes a full day, sometimes two if the substrate needs to dry out first. We’ll give you a real arrival window and a specific finish time before we start. Call (888) 426-8719 to schedule.
We source from the original label and measurements you give us, then confirm against the Mr-Glass model or series the part came from. If OEM is available, we’ll quote it. If a quality aftermarket equivalent (Blum, Grass, or similar) is a better fit or a better value, we’ll say so and explain why. Every part we install is covered by the 365-Day Done Right Promise and a written guarantee on the work. Call (888) 426-8719 for a free estimate.
If you’re in Sunnyvale and your Mr-Glass kitchen has a part that’s failing, the fastest path forward is a written price and a real plan. We’ll look at the label, the measurements, and the cabinet condition, then give you a number before anyone picks up a tool. Our technicians have up to 22 years of experience, and they arrive background-checked and in uniform. A live person answers the phone 24/7. We install KraftMaid, Wellborn, Cambria, Silestone, Caesarstone, Kohler and Moen products alongside Mr-Glass-compatible work, so whether you’re matching an existing run or replacing a whole cabinet bank, we can walk you through the options. Call (888) 426-8719 for your free estimate in Sunnyvale.
Written by the team at Penhallow Remodeling Sunnyvale, serving Sunnyvale and nearby areas.












