







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boral Bathroom Remodeling: The Sunnyvale Owner’s Guide
We install Boral-surface bathroom remodels for Sunnyvale homeowners, with typical installed projects running $9,000 – $28,000 depending on how far the work reaches. Replacement of a single failed Boral component – a cracked tile field, a lifted shower bench, a failing sill trim – usually sits at the low end of that range; a full bath rebuild lands at the top. We schedule free estimates, not same-day emergency installs, so plan on a measured conversation before any work begins.
Owners usually call us after a small defect stops being small. A hairline crack in the shower pan widens over a wet season. Grout at the mud sill or the bench seat starts crumbling and takes the tile face with it. A Boral sill or trim piece near a window in a Sunnyvale bath begins to chalk and swell. These are the visible symptoms of what’s happening underneath the tile – a moisture barrier that wasn’t installed to spec, a substrate that flexed, or a product installed outside its recommended application.
Which Boral Models This Applies To

Boral makes several distinct lines that show up in Sunnyvale bathrooms, and knowing which you have is the first honest step before any pricing conversation. The most common bath-relevant products are Boral ceramic and porcelain floor and wall tile, Boral’s stone-look porcelain planks, and Boral trim and sill profiles used at transitions. Each line has its own thickness and edge spec – porcelain planks often run 8mm to 10mm and mimic hardwood; a standard floor tile in the same family can be 10mm to 12mm. Mixing them at a threshold without a proper transition strip is one of the most common failures we correct.
Identification matters. Look on the original tile box (if you still have it), or on the back of a spare piece, for a printed series name and the printed size in millimeters. A 300mm tile is nominally 12 inches, but it is not the same as a 12×12 that measures exactly 12. Matching a discontinued Boral series is where most homeowners get stuck, because a close color match in a different series will read as noticeably different once installed.
OEM Boral replacement is the cleanest route when the series is still in production; a quality aftermarket equivalent – a domestically made porcelain or ceramic from a recognized trade brand – is the better answer when the Boral line has been discontinued or when the failure calls for a product upgrade rather than a swap. We source from recognized trade brands and explain the trade-off on paper before you decide. Penhallow Remodeling Sunnyvale is an independent remodeling provider and is not affiliated with Boral.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Boral Bathroom Remodeling Is Failing
- Cracks that spread from a corner or a drain. This is almost always a substrate flex issue, not a tile defect. Boral porcelain is strong in compression but doesn’t tolerate movement beneath it, and a 3/4-inch plywood subfloor installed over joists spaced wider than the tile spec allows will move enough to crack a field within a few seasons.
- Hollow sound when you tap a tile. A hollow ring means the thin-set bond has let go, often because the mortar skimmed over before the tile was set. Left alone, a hollow tile is the one most likely to lift or crack next.
- Grout crumbling at the shower bench, curb, or mud sill. Water reached the substrate. In Sunnyvale’s wet winters, that grout line is where moisture finds its way behind the tile and into the wall cavity – and it will not dry out on its own.
- Chalking or swelling on Boral trim and sill profiles. Exterior-facing bath windows often carry a Boral sill piece; if it wasn’t sealed to spec, the paint film fails and the profile begins to break down. This is a common call in the older 1950s-70s homes around downtown Sunnyvale.
- Lippage – uneven tile edges you can feel with a fingertip. Usually a large-format install on an unleveled substrate, or a Boral plank installed without the correct offset pattern. Lippage isn’t just cosmetic; the raised edge wears faster and traps water.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For a Sunnyvale bathroom project that replaces failed Boral tile and rebuilds the wet area properly, you’re looking at the full bathroom remodel range of $9,000 – $28,000 installed. A focused shower replacement without moving fixtures typically runs $3,000 – $8,500, and a walk-in shower installation runs $4,500 – $12,000. Tub-to-shower conversions land at $3,500 – $10,000. A small bathroom remodel at the tighter end sits at $5,000 – $12,000.
What drives the number up: whether the waterproofing layer (the membrane behind the tile that keeps water out of the wall) has to be replaced, whether the substrate needs new cement board, and whether the Boral series you have is still available or requires a substitute. What keeps it down: keeping the existing layout and fixtures.
Every price is written before work starts – not a range, not a verbal ballpark. That written price is the number on the invoice. Every job carries the 365-Day Done Right Promise: if the work fails inside that year, we come back and fix it at no charge. The guarantee is written on the estimate.
DIY or Call Us?
There’s a short list of things a homeowner can safely check on their own. Look for cracks wider than a hairline. Tap tile with a coin and listen for hollow spots. Press a fingertip along the bench and curb grout lines to feel for soft or crumbling sections. Check the caulk line where the tile meets the tub or shower base – a gap there is the most common entry point for water behind Boral tile.
What we’d gently steer you away from: pulling a set tile to “see what’s underneath.” Once a Boral tile comes up, the waterproofing membrane is compromised, and a re-set rarely matches the field. Removing a shower bench or tearing out a curb is the same story. The visible defect is often the smallest part of the problem, and a homeowner who opens the wall to check will almost always need to close it back up with a contractor anyway.
If you’re seeing any of the symptoms above, call us at (888) 426-8719 for a free written estimate. Estimates are free, and the phone is answered by a live person 24/7.
FAQs

A correctly installed Boral porcelain tile field in a Sunnyvale shower should last 25 to 40 years, but the waterproofing layer behind it has a shorter working life – typically 15 to 20 years depending on the membrane system used. The tile is not the part that fails first; the substrate and waterproofing are, which is why a 20-year-old shower can look fine and still be failing behind the wall. Call (888) 426-8719 if you suspect the membrane has reached the end of its service life – estimates are free.
Sometimes yes – a single cracked tile away from the wet area can often be replaced without disturbing the field, provided an identical Boral series replacement can be sourced. A crack near a drain, a curb, or a bench seat almost always signals a substrate or waterproofing failure that tile-level repair won’t fix. Call (888) 426-8719 for a free assessment.
A focused shower replacement typically runs 5 to 10 working days; a full bathroom remodel with new tile, waterproofing, and fixtures usually takes 3 to 5 weeks. The range depends on whether the substrate is sound, whether plumbing needs to move, and whether the Boral product you have is in stock or needs to be ordered. Call (888) 426-8719 to schedule a free estimate and get a written timeline.
We start with the series name and printed size on the back of a spare tile or the original box. If the Boral series is still in production, we order direct. If it’s discontinued, we walk you through a quality aftermarket equivalent from a recognized trade brand and explain the visual and performance difference in writing. Call (888) 426-8719 for a free estimate – we’ll tell you honestly whether a match is achievable before you commit.
When you’re ready to put a real number on the project, call Penhallow Remodeling Sunnyvale at (888) 426-8719 for a free estimate. We’ll walk the bathroom with you, write out the price and the 365-Day Done Right Promise before any work starts, and show up in the window we gave you. We also work with KraftMaid cabinetry, Cambria and Silestone countertops for homeowners considering the bath or kitchen as one combined project.
Written by the team at Penhallow Remodeling Sunnyvale, serving Sunnyvale and nearby areas.












