







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mighty Buildings Driveway & Pavers: The Sunnyvale Owner’s Guide
Replacing the driveway and paver surfaces on a Mighty Buildings home in Sunnyvale typically runs $7,000 – $18,000 for a paver driveway, $4,500 – $12,000 for concrete, and $250 – $700 for a reseal, depending on square footage, base condition, and whether the 3D-printed panel edge needs re-flashing. We’re an independent contractor, not affiliated with Mighty Buildings, and the earliest scheduled installs in Sunnyvale usually open up within one to two weeks once the estimate is signed.
Owners almost always find the problem the same way: a hairline crack in the driveway near the garage threshold that widens over a winter, or pavers on the south-facing walk that start rocking underfoot by late spring. On Mighty Buildings homes, the panel-to-slab seam sits closer to grade than on a stick-built house, so water that used to sheet away now pools at the joint. That’s the pattern we see most often in Sunnyvale, where the clay-heavy soil in neighborhoods like Serra Park and Washington Park swells after the rainy season and shrinks hard in July.
Key Takeaways
- Paver driveway in Sunnyvale: $7,000 – $18,000 installed. Concrete: $4,500 – $12,000.
- Mighty Buildings slab edges sit low, so drainage corrections are usually part of the job.
- Clay soil and seasonal movement are what crack most Sunnyvale driveways.
- Written price before work starts, 365-Day Done Right Promise included.
Which Mighty Buildings Models This Applies To

Mighty Buildings panelized and 3D-printed homes have varied slab edge profiles across production runs, and the driveway spec has followed those changes. The key is not the model name on your title but the actual slab reveal: how far the printed wall edge sits above the finished grade, and how the driveway meets it. We measure that reveal on every Sunnyvale estimate, because a driveway that ties in flush on one home needs a grouted transition strip or a low apron on another. Getting this wrong is the single most common installation mistake we correct.
To identify what your home needs, look for the stamped model designation on the utility panel or the original permit drawings. If neither is handy, we take three measurements: the slab reveal at the garage door, the driveway width, and the slope from garage to street. Those three numbers tell us more than a model name ever will.
On OEM versus aftermarket: the paver unit itself is not proprietary, so any quality brand like Belgard or Unilock works and carries its own manufacturer warranty alongside ours. What is worth matching carefully is the base specification and the edge restraint, because those are what the original build tuned to the printed panel. We don’t carry stock or keep parts on a truck; everything is ordered to your specific home once the spec is confirmed.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mighty Buildings Driveway & Pavers Is Failing
- Cracks radiating from the garage threshold. The slab edge and the driveway are moving at different rates, usually because the base compacted unevenly under that corner.
- Pavers that rock or settle in a pattern. Base failure below, not a paver failure. Re-sanding alone won’t fix it.
- Water pooling at the panel-to-driveway seam. The low slab reveal on Mighty Buildings homes stops water from sheeting away. This leads to freeze-thaw and clay expansion damage over a few seasons.
- Efflorescence or white staining on concrete. Moisture is wicking up through the slab. It signals a drainage problem, not a cosmetic one.
- Sunken or uneven edge restraint. The border has pulled away from the driveway edge, which lets soil and water in and lets pavers spread.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Pricing in Sunnyvale reflects the base work more than the surface material. Here’s what installs run:
| Job | Installed Range |
|---|---|
| Paver driveway | $7,000 – $18,000 |
| Concrete driveway | $4,500 – $12,000 |
| Asphalt paving | $3,500 – $9,000 |
| Driveway replacement (full tear-out) | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
| Paver patio | $3,500 – $11,000 |
The range is driven by square footage, base depth and compaction, drainage corrections at the Mighty Buildings slab seam, and material choice. We give you a written line-item quote before any work starts, and the number on day one is the number on the invoice. Every driveway install comes with our 365-Day Done Right Promise in writing, and if a repair fails inside that window we come back at no charge.
DIY or Call Us?
You can safely check a few things yourself. Walk the driveway after rain and mark where water pools. Photograph any cracks with a ruler alongside. Lift a loose paver and see whether the sand base beneath is wet or compacted. Those notes save time on the estimate.
What you shouldn’t attempt is a base repair or a full replacement yourself. A driveway that looks like surface work is actually a structural job: excavation, graded base, compaction in lifts, edge restraint, and tie-in to the slab edge. Skip any step and the same cracks return in one or two seasons. On a Mighty Buildings home, the slab seam connection is where a DIY fix most often goes wrong. Call (888) 426-8719 and we’ll give you a written estimate and a realistic window for the work.
FAQs

A properly based paver driveway lasts 25 to 30 years in Sunnyvale’s climate. The pavers outlast the base, and the base is where most failures start, especially with clay soil expanding and contracting each season.
Often yes. Sealing or crack-filling handles cosmetic issues under $700. If pavers are rocking or water is pooling at the Mighty Buildings slab seam, the base needs correcting and a full repair is usually the better spend.
A paver driveway on a typical Sunnyvale lot takes three to five days from tear-out to final compaction, weather permitting. Concrete takes two to three days plus a cure period before you drive on it. We give you the schedule in writing before we start.
We order to your confirmed spec from recognized trade brands like Belgard and Unilock, and we do not keep stock or carry parts on a truck. Every material is matched to your Mighty Buildings home’s slab profile and ordered per job.
Call (888) 426-8719 for a free estimate on your Mighty Buildings driveway or pavers in Sunnyvale. We also install cabinetry and stone from KraftMaid, Cambria and Silestone on interior remodels, so you have one contractor for the whole home if you need it.
Written by the team at Penhallow Remodeling Sunnyvale, serving Sunnyvale and nearby areas.












